CAN COMMUNICATION SYSTEM > Check CAN Bus Line (RHD Models) |


| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistance of the main wire and the branch wire.
| NEXT | |
| 2.CHECK CAN BUS WIRE (MAIN WIRE FOR DISCONNECTION, BUS LINES FOR SHORT CIRCUIT) |
![]() |
Measure the resistance of the DLC3.
| Tester Connection | Switch Condition | Specified Condition | Proceed to |
| E16-6 (CANH) - E16-14 (CANL) | Ignition switch off | 54 to 69 Ω | A |
| E16-6 (CANH) - E16-14 (CANL) | Ignition switch off | Higher than 69 Ω | B |
| E16-6 (CANH) - E16-14 (CANL) | Ignition switch off | Below 54 Ω | C |
|
| ||||
|
| ||||
| A | |
| 3.CHECK CAN BUS LINE FOR SHORT TO +B |
![]() |
Measure the resistance of the DLC3.
| Tester Connection | Switch Condition | Specified Condition |
| E16-6 (CANH) - E16-16 (BAT) | Ignition switch off | 6 kΩ or higher |
| E16-14 (CANL) - E16-16 (BAT) | Ignition switch off | 6 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK CAN BUS LINE FOR SHORT TO GND |
![]() |
Measure the resistance of the DLC3.
| Tester Connection | Switch Condition | Specified Condition |
| E16-6 (CANH) - E16-4 (CG) | Ignition switch off | 200 Ω or higher |
| E16-14 (CANL) - E16-4 (CG) | Ignition switch off | 200 Ω or higher |
|
| ||||
| OK | ||
| ||