CAN COMMUNICATION SYSTEM > Air Conditioning Amplifier Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Air Conditioning Amplifier Communication Stop Mode | Either condition is met:
|
|


| 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistance of the main wire and the branch wire.
| NEXT | |
| 2.CHECK CAN BUS LINE FOR DISCONNECTION (AIR CONDITIONING AMPLIFIER BRANCH WIRE) |
![]() |
Disconnect the E41*1 or E42*2 air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E41-11 (CANH) - E41-12 (CANL) | Ignition switch off | 54 to 69 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| E42-8 (CANH) - E42-9 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND) |
Connect the cable to the negative (-) battery terminal.
![]() |
Disconnect the E41*1 or E42*2 air conditioning amplifier connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E41-14 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E42-24 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E41-21 (B) - Body ground | Always | 11to 14 V |
| E41-1 (IG+) - Body ground | Ignition switch on (IG) | 11to 14 V |
| Tester Connection | Switch Condition | Specified Condition |
| E42-14 (IG+) - Body ground | Ignition switch on (IG) | 11 to 14 V |
|
| ||||
| OK | ||
| ||