Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › SPEED SENSOR

SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SPEED SENSOR NC


    C133979
  1. Coat a new O-ring with ATF.

  1. Install the O-ring to the sensor.

  1. Install the sensor with the bolt.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

  1. Connect the sensor connector.



2. INSTALL SPEED SENSOR NT


    C133978
  1. Coat a new O-ring with ATF.

  1. Install the O-ring to the sensor.

  1. Install the sensor with the bolt.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

  1. Connect the sensor connector.



3. INSTALL BATTERY BRACKET REINFORCEMENT


    A124919
  1. Install the bracket reinforcement with the 2 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }



4. INSTALL FRONT BATTERY BRACKET


    A173727
  1. Install the front battery bracket with the 4 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. Attach the 2 wire harness clamps.



5. INSTALL BATTERY


6. INSTALL BATTERY CLAMP SUB-ASSEMBLY
  1. Attach the hook of the battery clamp to the front battery bracket.

  1. Temporarily tighten the nut and install the bolt.

  1. Adjust the battery clamp position.



    A124917E01
  1. Fully tighten the nut and bolt.

    Torque:
    Bolt:
    17 N*m{ 170 kgf*cm , 12 ft.*lbf }
    Nut:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }

  1. Attach the 2 wire harness clamps.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL