Home › TRANSMISSION ยท U241E AUTOMATIC TRANSAXLE › SPEED SENSOR

SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SPEED SENSOR NC


C127799
  1. Coat a new O-ring with ATF.

  1. Install the O-ring to the sensor.

  1. Install the sensor with the bolt.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

  1. Connect the sensor connector.



2. INSTALL SPEED SENSOR NT


C127798
  1. Coat a new O-ring with ATF.

  1. Install the O-ring to the sensor.

  1. Install the sensor with the bolt.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

  1. Connect the sensor connector.



3. INSTALL BATTERY
  1. Install the battery bracket reinforcement with the 2 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Install the battery carrier with the 4 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. Install the battery tray.

  1. Install the battery with the battery clamp.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf } for bolt
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf } for nut



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL