Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › SPEED SENSOR

SPEED SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    A124917E01
  1. Remove the bolt and loosen the nut.

  1. Detach the 2 wire harness clamps.

  1. Detach the hook of the battery clamp from the front battery bracket, and then remove the battery clamp.



3. REMOVE BATTERY


4. REMOVE FRONT BATTERY BRACKET


    A173727
  1. Detach the 2 wire harness clamps.

  1. Remove the 4 bolts and front bracket.



5. REMOVE BATTERY BRACKET REINFORCEMENT


    A124919
  1. Remove the 2 bolts and bracket reinforcement.



6. REMOVE SPEED SENSOR NT


    C133978
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.

  1. Remove the O-ring from the sensor.



7. REMOVE SPEED SENSOR NC


    C133979
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.

  1. Remove the O-ring from the sensor.