Home › TRANSMISSION ยท U241E AUTOMATIC TRANSAXLE › SPEED SENSOR

SPEED SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE BATTERY
  1. Loosen the nut and remove the bolt and battery clamp.

  1. Remove the battery.

  1. Remove the battery tray.

  1. Remove the 4 bolts and battery carrier.

  1. Remove the 2 bolts and battery bracket reinforcement.



3. REMOVE SPEED SENSOR NT


C127798
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.

  1. Remove the O-ring from the sensor.



4. REMOVE SPEED SENSOR NC


C127799
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.

  1. Remove the O-ring from the sensor.