PARK / NEUTRAL POSITION SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE BATTERY |
Loosen the nut and remove the bolt and battery clamp.
Remove the battery.
Remove battery tray.
Remove the 4 bolts and battery carrier.
Remove the 2 bolts and battery bracket reinforcement.
| 3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Disconnect the switch connector.
![]() |
Remove the nut and disconnect the control cable from the control shaft lever.
![]() |
Remove the nut, washer and control shaft lever.
![]() |
Using a screwdriver, pry off the lock plate.
Remove the nut and lock plate.
![]() |
Remove the 2 bolts and pull out the switch.