Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    A124917E01
  1. Remove the bolt and loosen the nut.

  1. Detach the 2 wire harness clamps.

  1. Detach the hook of the battery clamp from the front battery bracket, and then remove the battery clamp.



3. REMOVE BATTERY


4. REMOVE FRONT BATTERY BRACKET


    A173727
  1. Detach the 2 wire harness clamps.

  1. Remove the 4 bolts and front bracket.



5. REMOVE BATTERY BRACKET REINFORCEMENT


    A124919
  1. Remove the 2 bolts and bracket reinforcement.



6. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    C133983
  1. Disconnect the switch connector from the park/neutral position switch assembly.



    C133984
  1. Remove the nut and disconnect the control cable from the control shaft lever.



    C133985
  1. Remove the nut, washer and control shaft lever.



    C133986
  1. Using a screwdriver, pry out the lock plate.

  1. Remove the nut and lock plate.



    C133987
  1. Remove the 2 bolts and pull out the park/neutral position switch assembly.