Home › TRANSMISSION ยท U140F AUTOMATIC TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION WIRE


    D003636E02
  1. Coat a new O-ring of the transmission wire connector with ATF.



    C127829
  1. Install the transmission wire.

  1. Install the bolt.

  1. Connect the connector.



    D025591E01
  1. Coat the O-ring of the ATF temperature sensor with ATF.

  1. Install the ATF temperature sensor with the lock plate and bolt.

    Torque:
    6.6 N*m{ 67 kgf*cm , 58 in.*lbf }

  1. Connect the 5 shift solenoid valve connectors.



2. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    C134981E01
  1. Install the 3 magnets in the oil pan.



    C083111E01
  1. Install a new gasket and the oil pan with the 18 bolts.

    Torque:
    7.6 N*m{ 77 kgf*cm , 67 in.*lbf }



3. INSTALL NO. 1 ENGINE UNDER COVER


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:
Toyota Genuine ATF WS



6. INSPECT TRANSAXLE FLUID LEVEL
  1. Inspect the fluid level (Click here).



7. PERFORM RESET MEMORY
  1. Perform the RESET MEMORY procedures (A/T initialization) (Click here).