TRANSMISSION WIRE > INSTALLATION |
| 1. INSTALL TRANSMISSION WIRE |
![]() |
Coat a new O-ring of the transmission wire connector with ATF.
![]() |
Install the transmission wire.
Install the bolt.
Connect the connector.
![]() |
Coat the O-ring of the ATF temperature sensor with ATF.
Install the ATF temperature sensor with the lock plate and bolt.
Connect the 5 shift solenoid valve connectors.
| 2. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
![]() |
Install the 3 magnets in the oil pan.
![]() |
Install a new gasket and the oil pan with the 18 bolts.
| 3. INSTALL NO. 1 ENGINE UNDER COVER |
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. ADD AUTOMATIC TRANSAXLE FLUID |
| 6. INSPECT TRANSAXLE FLUID LEVEL |
Inspect the fluid level (Click here).
| 7. PERFORM RESET MEMORY |
Perform the RESET MEMORY procedures (A/T initialization) (Click here).