Home › TRANSMISSION · U151F AUTOMATIC TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > INSPECTION

for Preparation Click here



1. INSPECT TRANSMISSION WIRE


    C129039E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 (THO) - 6 (E2)
    90 Ω to 156 kΩ
    1 (THO) - Body ground
    1 MΩ or higher
    6 (E2) - Body ground
    1 MΩ or higher

    If the result is not as specified, replace the wire.

    HINT:
    If the resistance is not as specified for either of the ATF temperatures shown in the table below, the drivability of the vehicle may decrease.

    Standard resistance:
    ATF Temperature
    Specified Condition
    10°C (50°F)
    6.4 kΩ
    110°C (230°F)
    0.2 kΩ