PARK / NEUTRAL POSITION SWITCH > INSTALLATION |
| 1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Install the park/neutral position switch assembly to the manual valve shaft.
Temporarily install the 2 bolts.
![]() |
Install a new lock plate and the manual valve shaft nut.
Temporarily install the control shaft lever.
![]() |
Turn the lever counterclockwise until it stops, and then turn it clockwise 2 notches.
Remove the control shaft lever.
![]() |
Align the groove and neutral basic line.
Hold the park/neutral position switch assembly in this position and tighten the 2 bolts.
![]() |
Using a screwdriver, stake the nut with the lock washer.
![]() |
Install the control shaft lever with the washer and nut.
Connect the shift control cable to the control shaft lever with the nut.
Connect the connector to the park/neutral position switch assembly.
| 2. INSTALL BATTERY BRACKET REINFORCEMENT |
![]() |
Install the bracket reinforcement with the 2 bolts.
| 3. INSTALL FRONT BATTERY BRACKET |
![]() |
Install the front battery bracket with the 4 bolts.
Attach the 2 wire harness clamps.
| 4. INSTALL BATTERY |
| 5. INSTALL BATTERY CLAMP SUB-ASSEMBLY |
Attach the hook of the battery clamp to the front battery bracket.
Temporarily tighten the nut and install the bolt.
Adjust the battery clamp position.
![]() |
Fully tighten the nut and bolt.
Attach the 2 wire harness clamps.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. ADJUST SHIFT LEVER POSITION |
Adjust the shift lever position (Click here).
| 8. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Inspect the switch (Click here).