Home › TRANSMISSION ยท U140F AUTOMATIC TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY


C134995E01
  1. Install the 5 shift solenoid valves with the 5 bolts and 4 plates.

    Torque:
    6.6 N*m{ 67 kgf*cm , 58 in.*lbf } for bolt A
    11 N*m{ 112 kgf*cm , 8 ft.*lbf } for bolt B

    HINT:
    Each bolt length is indicated below.

    Bolt length:
    12 mm (0.47 in.) for Bolt A
    45 mm (1.77 in.) for Bolt B



    C050017E01
  1. Install the spring and check ball body.



    D003553E10
  1. Align the groove of the manual valve with the pin of lever.

  1. Install the 17 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    NOTICE:
    1. Push the valve body against the accumulator piston spring and the check ball body to install it.
    2. Tighten the bolts marked by * in the illustration first temporarily because they are positioning bolts.

    HINT:
    Each bolt length is indicated below.

    Bolt length:
    25 mm (0.984 in.) for Bolt A
    41 mm (1.614 in.) for Bolt B
    45 mm (1.771 in.) for Bolt C



2. INSTALL TRANSMISSION WIRE


C130917E01
  1. Coat the O-ring of the temperature sensor with ATF.

  1. Install the ATF temperature sensor with the lock plate and bolt.

    Torque:
    6.6 N*m{ 67 kgf*cm , 58 in.*lbf }

  1. Connect the 5 shift solenoid valve connectors.



3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


C069150E01
  1. Coat a new O-ring with ATF.

  1. Install the O-ring to the oil strainer.



    D009179E01
  1. Install the oil strainer with the 3 bolts.

    Torque:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }



4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


C134981E01
  1. Install the 3 magnets in the oil pan.



    C083111E01
  1. Install a new gasket and oil pan with the 18 bolts.

    Torque:
    7.6 N*m{ 77 kgf*cm , 67 in.*lbf }



5. INSTALL NO. 1 ENGINE UNDER COVER


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:
Toyota Genuine ATF WS



8. INSPECT TRANSAXLE FLUID LEVEL
  1. Inspect the fluid level (Click here).



9. PERFORM RESET MEMORY
  1. Perform the RESET MEMORY procedures (A/T initialization) (Click here).