SHIFT LOCK SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK SHIFT LOCK OPERATION |
Move the shift lever to P.
Turn the ignition switch off.
Check that the shift lever cannot be moved to any position other than P.
Turn the ignition switch on (IG), depress the brake pedal and check that the shift lever can be moved to other positions.
| 2. CHECK SHIFT LOCK RELEASE BUTTON OPERATION |
When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position other than P. If the operation cannot be performed as specified, check the shift lever assembly.
| 3. CHECK KEY INTERLOCK OPERATION (w/o Entry and Start System) |
Turn the ignition switch to the ON position.
Depress the brake pedal and move the shift lever to any position other than P.
Check that the ignition key cannot be turned to the LOCK position.
Move the shift lever to P, turn the ignition key to the LOCK position and check that the ignition key can be removed. If the results are not as specified, inspect the shift lock control unit.
| 4. CHECK SHIFT LOCK CONTROL UNIT ASSEMBLY (w/ Entry and Start System) |
![]() |
Measure the voltage of the connector.
| Tester Connection | Condition | Specified Condition |
| 4 (STP) - 1 (E) | Depress brake pedal | 10 to 14 V |
| 4 (STP) - 1 (E) | Release brake pedal | Below 1 V |
| 8 (IG) - 1 (E) | Ignition switch on (IG) | 10 to 14 V |
| 8 (IG) - 1 (E) | Ignition switch off | Below 1 V |
![]() |
Measure the resistance of the connector.
| Tester Connection | Measuring Condition | Specified Condition |
| 1 (E) - Body ground | Always | Below 1 Ω |
| 5. CHECK SHIFT LOCK CONTROL UNIT ASSEMBLY (w/o Entry and Start System) |
![]() |
Measure the voltage of the connector.
| Tester Connection | Condition | Specified Condition |
| 6 (ACC) - 1 (E) | Ignition switch ON | 10 to 14 V |
| 6 (ACC) - 1 (E) | Ignition switch ACC | 10 to 14 V |
| 6 (ACC) - 1 (E) | Ignition switch OFF | Below 1 V |
| 4 (STP) - 1 (E) | Depress brake pedal | 10 to 14 V |
| 4 (STP) - 1 (E) | Release brake pedal | Below 1 V |
| 5 (KLS+) - 1 (E) | Ignition switch ACC and shift lever on P | Below 1 V |
| 5 (KLS+) - 1 (E) | Ignition switch ACC and shift lever not on P | 7.5 to 11 V |
| 5 (KLS+) - 1 (E) | Ignition switch ACC and shift lever not on P (after approx. 1 second) | 6 to 9 V |
| 8 (IG) - 1 (E) | Ignition switch ON | 10 to 14 V |
| 8 (IG) - 1 (E) | Ignition switch OFF | Below 1 V |
![]() |
Measure the resistance of the connector.
| Tester Connection | Measuring Condition | Specified Condition |
| 1 (E) - Body ground | Always | Below 1 Ω |