AUTOMATIC TRANSAXLE ASSEMBLY > INSTALLATION |
| 1. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Inspect the torque converter clutch (Click here).
| 2. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY |
Install the torque converter clutch to the automatic transaxle.
![]() |
Using a vernier caliper, measure dimension A between the transaxle and end surface of the drive plate.
![]() |
Using a vernier caliper and straightedge, measure dimension B shown in the illustration and check that B is greater than A.
| 3. INSTALL AUTOMATIC TRANSMISSION CASE PROTECTOR |
Install the protector with the 2 bolts.
| 4. INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET |
![]() |
Install the cable bracket with the 2 bolts.
| 5. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
![]() |
Install the filler tube with the bolt.
Install the ATF dipstick.
| 6. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY |
![]() |
Install the automatic transaxle to the engine with the 7 upper side mounting bolts.
![]() |
Install the 3 lower side mounting bolts.
![]() |
Install the 6 torque converter clutch mounting bolts.
![]() |
Install the flywheel housing under cover with the 2 bolts.
| 7. INSTALL TRANSFER ASSEMBLY |
![]() |
except K111F:
Install the transfer to the transaxle with the 6 nuts and 2 bolts.
![]() |
for K111F:
Install the transfer to the transaxle with the 6 nuts and 2 bolts.
| 8. INSTALL ENGINE MOUNTING BRACKET LH |
![]() |
Install the mounting bracket with the 4 bolts.
| 9. INSTALL FRONT ENGINE MOUNTING BRACKET |
![]() |
Install the mounting bracket with the 4 bolts.
| 10. INSTALL REAR ENGINE MOUNTING BRACKET |
![]() |
Install the mounting bracket with the 3 bolts.
| 11. CONNECT OIL COOLER INLET HOSE |
![]() |
Connect the hose to the transaxle and transmission oil filler tube.
| 12. INSTALL OIL COOLER TUBE SUB-ASSEMBLY |
![]() |
Install the tube with the bolt.
| 13. INSTALL OIL COOLER OUTLET HOSE |
![]() |
Connect the hose to the transaxle and oil cooler tube.
| 14. CONNECT WIRE HARNESS |
![]() |
Connect the wire harness clamps.
Connect the 2 speed sensor connectors.
Connect the transaxle wire connector.
Connect the park/neutral position switch connector.
| 15. INSTALL STARTER ASSEMBLY |
![]() |
Install the starter with the 2 bolts.
Connect the starter connector.
![]() |
Install the terminal nut and close the terminal cap.
| 16. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE |
| 17. ADD AUTOMATIC TRANSAXLE FLUID |
| 18. INSPECT AUTOMATIC TRANSAXLE FLUID |
Park the vehicle on a level surface and apply the parking brake.
![]() |
With the engine idling and the brake pedal depressed, move the shift lever to each position from the P position to the L position, and return it to the P position.
Pull out the dipstick and wipe it clean.
Push it back fully into the pipe.
Pull it out again and check that the fluid level is within the HOT range. If the fluid level is below the HOT range, add new fluid and recheck the fluid level. If the fluid level exceeds the HOT range, drain the fluid once, add a proper amount of new fluid and recheck the fluid level.
| 19. PERFORM RESET MEMORY |
Perform the RESET MEMORY procedures (A/T initialization) (Click here).