Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE ASSEMBLY

AUTOMATIC TRANSAXLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
(Click here)



2. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain the ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



3. REMOVE STARTER ASSEMBLY


    A126954
  1. Disconnect the starter connector.

  1. Open the terminal cap, remove the nut, and disconnect the starter wire.



    A126955
  1. Remove the 2 bolts and starter.



4. DISCONNECT WIRE HARNESS


    C134973
  1. Disconnect the park/neutral position switch connector.

  1. Disconnect the transaxle wire connector.

  1. Disconnect the 2 speed sensor connectors.

  1. Disconnect the wire harness clamps.



5. DISCONNECT OIL COOLER TUBE SUB-ASSEMBLY


    C133996
  1. Disconnect the oil cooler outlet hose from the oil cooler tube and transaxle.

  1. Remove the bolt and oil cooler tube.



6. DISCONNECT OIL COOLER OUTLET HOSE
  1. Disconnect the oil cooler outlet hose from the transaxle.



7. DISCONNECT OIL COOLER INLET HOSE


    C133997
  1. Disconnect the hose from the transmission oil filler tube and transaxle, and remove it.



8. REMOVE REAR ENGINE MOUNTING BRACKET


    C134976
  1. Remove the 3 bolts and mounting bracket.



9. REMOVE FRONT ENGINE MOUNTING BRACKET


    C134977
  1. Remove the 4 bolts and mounting bracket.



10. REMOVE ENGINE MOUNTING BRACKET LH


    C134978
  1. Remove the 4 bolts and mounting bracket.



11. REMOVE TRANSFER ASSEMBLY


    C126622
  1. except K111F:
    Remove the 6 nuts, 2 bolts and transfer from the transaxle.



    C130224
  1. for K111F:
    Remove the 6 nuts and transfer from the transaxle.



12. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY


    D030471E01
  1. Remove the 2 bolts and flywheel housing under cover.



    D030472E01
  1. Turn the crankshaft to gain access and remove the 6 bolts while holding the crankshaft pulley bolt with a wrench.



    C136364
  1. Remove the 3 lower side mounting bolts.



    C134974
  1. Remove the 7 upper side mounting bolts.

  1. Separate and remove the automatic transaxle.



13. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


    C134979
  1. Remove the ATF dipstick.

  1. Remove the bolt and oil filler tube.



14. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET


    C134980
  1. Remove the 2 bolts and cable bracket.



15. REMOVE AUTOMATIC TRANSMISSION CASE PROTECTOR
  1. Remove the 2 bolts and protector.



16. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY