Home › TRANSMISSION ยท U140F AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE UNIT

AUTOMATIC TRANSAXLE UNIT > INSPECTION

for Preparation Click here



1. INSPECT AUTOMATIC TRANSAXLE OIL PANEL SUB-ASSEMBLY


AT00103E01
  1. Remove the magnets and use them to collect any steel chips. Examine the chips and particles in the pan and on the magnet to determine what type of wear has occurred in the transaxle.
    Steel (magnetic): bearing gear and plate wear
    Brass (non-magnetic): bush wear



2. INSPECT INPUT SHAFT END PLAY


D008046E01
  1. Using a dial indicator, measure the input shaft end play.

    Standard end play:
    0.262 to 1.249 mm (0.0103 to 0.0492 in.)



3. INSPECT MULTIPLE DISC CLUTCH HUB


D003829E03
  1. Using a caliper gauge, measure the inside diameter of the forward clutch hub bushing.

    Standard inside diameter:
    23.025 to 23.045 mm (0.9065 to 0.9073 in.)

    Maximum inside diameter:
    23.09 mm (0.9091 in.)

    NOTICE:
    1. When the diameter is over the maximum, replace the multiple disc clutch hub with a new one.
    2. Check the contact surface of the bush in the direct clutch shaft. If any scratch or discolor is identified, replace the direct clutch sub-assembly with a new one.

    If the inside diameter is greater then the maximum, replace the forward clutch hub.



4. INSPECT NO. 2 UNDERDRIVE CLUTCH DISC


D009196E01
  1. Check to see if the sliding surface of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the groove is defaced, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.



5. INSPECT UNDERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY


D003806E01
  1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    14.04 mm (0.5528 in.)



6. INSPECT 2ND BRAKE CLUTCH DISC


D004083E01
  1. Check to see if the sliding surface of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the printed number is defaced, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.



7. INSPECT 1ST AND REVERSE BRAKE CLUTCH DISC


D009189E01
  1. Check to see if the sliding surface of the disc, plate and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of the disc is peeling off or discolored, or even if a part of the groove is defaced, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.



8. INSPECT 1ST AND REVERSE BRAKE RETURN SPRING SUB-ASSEMBLY


D003811E01
  1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    15.51 mm (0.6106 in.)



9. INSPECT UNDERDRIVE 1-WAY CLUTCH ASSEMBLY


D003925E02
  1. Install the underdrive clutch assembly to the 1-way clutch. Rotate the underdrive clutch assembly to check the rotating direction for the lock or free operation.