OIL PUMP > DISASSEMBLY |
| 1. INSPECT OIL PUMP ASSEMBLY |
![]() |
Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly.
| 2. REMOVE CLUTCH DRUM OIL SEAL RING |
![]() |
Remove the 2 clutch drum oil seal rings.
| 3. REMOVE STATOR SHAFT ASSEMBLY |
![]() |
Using a T30 ''torx'' socket, remove the 11 bolts and stator shaft. Keep the gears in assembling order.
| 4. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
![]() |
Push the driven gear to one side of the body. Using a feeler gauge, measure the clearance.
![]() |
Measure the tip clearance between the driven gear teeth and drive gear teeth.
![]() |
Using a straightedge and feeler gauge, measure the side clearance of both gears.
| Mark | Thickness |
| 1 | 10.690 to 10.699 mm (0.4209 to 0.4212 in.) |
| 2 | 10.700 to 10.709 mm (0.4213 to 0.4216 in.) |
| 3 | 10.710 to 10.720 mm (0.4217 to 0.4220 in.) |
| 4 | 10.721 to 10.730 mm (0.4221 to 0.4224 in.) |
| 5 | 10.731 to 10.740 mm (0.4225 to 0.4228 in.) |
| Mark | Thickness |
| 1 | 10.690 to 10.699 mm (0.4209 to 0.4212 in.) |
| 2 | 10.700 to 10.709 mm (0.4213 to 0.4216 in.) |
| 3 | 10.710 to 10.720 mm (0.4217 to 0.4220 in.) |
| 4 | 10.721 to 10.730 mm (0.4221 to 0.4224 in.) |
| 5 | 10.731 to 10.740 mm (0.4225 to 0.4228 in.) |
| 5. REMOVE FRONT OIL PUMP DRIVE GEAR |
![]() |
Remove the front oil pump drive gear.
| 6. REMOVE FRONT OIL PUMP DRIVEN GEAR |
![]() |
Remove the front oil pump driven gear.
| 7. REMOVE FRONT OIL PUMP BODY O-RING |
![]() |
Using a screwdriver, pry out the O-ring.
| 8. REMOVE FRONT OIL PUMP OIL SEAL |
![]() |
Mount the oil pump in a soft jaw vise.
Using SST, tap out the oil seal from the oil pump body.
| 9. INSPECT FRONT OIL PUMP AND GEAR BODY SUB-ASSEMBLY |
![]() |
Using a caliper gauge, measure the inside diameter of the oil pump body bush.
| 10. INSPECT STATOR SHAFT ASSEMBLY |
![]() |
Using a caliper gauge, measure the inside diameter of the stator shaft bush.