Home › TRANSMISSION ยท U140F AUTOMATIC TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


D003654E01
  1. Using SST and a hammer, install a new oil seal to the pump.

    SST
    09350-32014   (09351-32140)

    HINT:
    The seal end should be flat with the outer edge of the oil pump.

  1. Coat the lip of the oil seal with petroleum jelly.



2. INSTALL FRONT OIL PUMP BODY O-RING


C055817E03
  1. Coat the new O-ring with ATF, and install it to the oil pump body.



3. INSTALL FRONT OIL PUMP DRIVEN GEAR


D009206E08
  1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing up.



4. INSTALL FRONT OIL PUMP DRIVE GEAR


D009206E09
  1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing up.



5. INSTALL STATOR SHAFT ASSEMBLY


D003651E02
  1. Set the stator shaft by aligning each bolt hole.

  1. Using a T30 ''trox'' socket, install the 11 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



6. INSTALL CLUTCH DRUM OIL SEAL RING


D003655E01
  1. Install the 2 clutch drum oil seal rings.

    NOTICE:
    Do not expand the ring ends excessively.



7. INSPECT OIL PUMP ASSEMBLY


D009205E01
  1. Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly.

    NOTICE:
    Be careful not to damage the oil seal lip.