Home › TRANSMISSION ยท U140F AUTOMATIC TRANSAXLE › UNDERDRIVE CLUTCH

UNDERDRIVE CLUTCH > INSPECTION

for Preparation Click here



1. INSPECT UNDERDRIVE CLUTCH PACK CLEARANCE


D008123E01
  1. Install the underdrive clutch to the transaxle.

    NOTICE:
    Be careful not to damage the oil seal rings.

  1. Install a dial indicator as shown in the illustration.



    D003700E01
  1. Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0kgf/cm2, 57 psi)

    Standard pack clearance:
    1.51 to 1.90 mm (0.0594 to 0.0748 in.)

    If the pack clearance is not as specified, inspect the discs, plates and flange.



2. INSPECT NO. 1 UNDERDRIVE CLUTCH DISC


D004077E01
  1. Check to see if the sliding surface of the disc, plate and flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the discs is peeling off or discolored, or even if a part of the printed mark is defaced, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.



3. INSPECT UNDERDRIVE CLUTCH DRUM SUB-ASSEMBLY


D008129E02
  1. Using a caliper gauge measure the inside diameter of the underdrive clutch drum bush.

    Standard drum bush:
    37.06 to 37.08 mm (1.4591 to 1.4598 in.)

    Maximum drum bush:
    37.13 mm (1.4618 in.)

    If the inside diameter is greater then the maximum, replace the underdrive clutch drum sub-assembly.



4. INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY


D003824E02
  1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    17.14 mm (0.6752 in.)