UNDERDRIVE PLANETARY GEAR > DISASSEMBLY |
| 1. REMOVE UNDERDRIVE PLANETARY GEAR PRELOAD |
![]() |
Using SST, fix the underdrive planetary gear.
![]() |
Using SST and a torque wrench, measure the turning torque of the underdrive planetary gear in place while rotating the torque wrench at 60 rpm.
| 2. REMOVE UNDERDRIVE INPUT SHAFT NUT |
![]() |
Using SST, loosen the staked part of the nut.
![]() |
Clamp the underdrive planetary gear in soft jaw vise.
![]() |
Using SST, remove the lock nut.
| 3. REMOVE CYLINDRICAL ROLLER BEARING INNER RACE |
![]() |
Using SST, remove the cylindrical roller bearing race inner.
| 4. REMOVE UNDERDRIVE PLANETARY GEAR ASSEMBLY |
![]() |
Using SST and a press, remove the differential drive pinion, parking lock gear, counter driven gear with underdrive planetary ring gear and front tapered roller bearing.
![]() |
Clamp the underdrive planetary gear in soft jaw vise.
Using SST, remove the rear tapped roller bearing from the underdrive planetary gear.
| 5. REMOVE UNDERDRIVE PLANETARY RING GEAR |
![]() |
Using snap ring pliers, remove the snap ring.
![]() |
Remove the underdrive planetary ring gear from the counter driven gear.