ELECTRONIC POWER STEERING SYSTEM > PRECAUTION |
| 1.HANDLING PRECAUTION |
When handling the electronic parts:
When handling the steering column:
When disconnecting and reconnecting the connectors:
| 2.PRECAUTIONS FOR CAN COMMUNICATION |
CAN communication lines are used to receive information from the skid control ECU and the ECM, and to transmit warnings to the combination meter.
When there are any problems in the CAN communication lines, DTCs of the CAN communication line are output.
Perform troubleshooting for the communication line problems when the CAN communication DTCs are output. Be sure to start troubleshooting on the electronic power steering system after confirming that the CAN communication system is normal.
Since the CAN communication line has its own length and route, it cannot be repaired temporarily with a bypass wire, etc.
| 3.IGNITION SWITCH EXPRESSIONS |
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (position) | Engine Switch (condition) |
| Ignition Switch off | LOCK | Off |
| Ignition Switch on (IG) | ON | On (IG) |
| Ignition Switch on (ACC) | ACC | On (ACC) |
| Engine Start | START | Start |