ELECTRONIC POWER STEERING SYSTEM > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
![]() |
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus [+] line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) -Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | HIGH-level CAN bus line | Ignition switch off* | 54 to 69 Ω |
| CANH (6) - Battery positive | HIGH-level CAN bus line | Ignition switch off* | 1 MΩ or higher |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch off* | 200 Ω or higher |
| CANL (14) - Battery positive | LOW-level CAN bus line | Ignition switch off* | 1 MΩ or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Ignition switch off* | 200 Ω or higher |
| CHECK WARNING LIGHT |
![]() |
When a problem occurs in the electronic power steering system, the P/S warning light on the combination meter comes on to inform the driver of the problem.