STEERING LOCK SYSTEM > TERMINALS OF ECU |
| CHECK STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) |

Disconnect the E6 steering lock actuator connector.
Measure the voltage and resistance of the wire harness side connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified condition |
| GND (E6-1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| SGND (E6-2) - Body ground | BR - Body ground | Signal ground | Always | Below 1 Ω |
| IG2 (E6-6) - GND (E6-1) | B - W-B | IG signal input | Engine switch on (IG) | 11 to 14 V |
| B (E6-7) - GND (E6-1) | L - W-B | Power source | Always | 11 to 14 V |
Reconnect the E6 steering lock actuator connector.
Measure the voltage of the connector.
| Symbols (Terminal No.) | Wiring Color | Terminal Description | Condition | Specified condition |
| IGE (E6-3) - GND (E6-1) | Y - W-B | Power source for motor drive | Motor in operation | Below 1 V |
| Motor not in operation | 11 to 12 V | |||
| SLP1 (E6-4) - SGND (E6-2) | G - BR | Unlock position sensor output signal | Steering locked | 11 to 14 V |
| Steering lock released | Below 1 V | |||
| LIN (E6-5) - SGND (E6-2) | V - BR | LIN communication bus | Engine switch on (IG) | Pulse generation |