STEERING LOCK SYSTEM > Power Source Circuit |

| 1.CHECK WIRE HARNESS (STEERING LOCK ACTUATOR - BODY GROUND) |
![]() |
Disconnect the E6 steering lock actuator connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| E6-1 (GND) - Body ground | Below 1 Ω |
| E6-2 (SGND) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (BATTERY - STEERING LOCK ACTUATOR) |
![]() |
Disconnect the E6 steering lock actuator connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| E6-7 (B) - E6-1 (GND) | 11 to 14 V |
| E6-7 (B) - E6-2 (SGND) | 11 to 14 V |
|
| ||||
| OK | ||
| ||