DTC B2786 No Response from Steering Lock ECU |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2786 | Certification ECU does not receive LIN communication from steering lock ECU for 10 seconds |
|

| 1.CHECK DTC (CERTIFICATION ECU) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and press the intelligent tester main switch ON.
Clear the DTCs of the certification ECU by following the prompts displayed on the intelligent tester.
Recheck for DTC.
| Result | Proceed to |
| B2786 output reoccurs | A |
| B2786 output does not reoccur | B |
|
| ||||
| A | |
| 2.CHECK WIRE HARNESS (CERTIFICATION ECU - STEERING LOCK ECU) |

Disconnect the E63 certification ECU connector.
Disconnect the E6 steering lock actuator connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E63-10 (LIN) - E6-5 (LIN) | Below 1 Ω |
| E6-5 (LIN) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK OPERATION OF CERTIFICATION ECU |
Replace the certification ECU with a normally functioning or new one.
Check for DTC.
| Result | Proceed to |
| B2786 output reoccurs | A |
| B2786 output does not reoccur | B |
|
| ||||
| A | ||
| ||