Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

DTC    B2789    No Response from ID BOX

for Preparation Click here


DESCRIPTION

This DTC is output when the certification ECU does not receive LIN communication signals from the ID code box via LIN for 10 seconds.

DTC Code
DTC Detection Condition
Trouble Area
B2789
Certification ECU does not receive LIN communication signals from ID code box via LIN for 10 seconds
  1. Wire harness
  2. ID code box
  3. ECU aggregation box (certification ECU)

WIRING DIAGRAM


B131382E01


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Recheck for the DTC.

    OK:
    B2789 output does not reoccur.



OK
NORMAL
NG


2.CHECK WIRE HARNESS (CERTIFICATION ECU - ID CODE BOX)

B109909E06

  1. Disconnect the E63 ECU connector.

  1. Disconnect the E51 box connector.

  1. Measure the resistance of the wire harness connectors.

    Standard Resistance:
    Tester Connection
    Specified Condition
    LIN (E63-10) - LIN1 (E51-3)
    Below 1 Ω
    LIN (E63-10) or LIN1 (E51-3) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK ECU AGGREGATION BOX (OPERATION)
  1. Temporarily replace the ECU aggregation box (certification ECU) with a new or normally functioning one.

  1. Check for DTC.

    OK:
    B2789 is not output.



NG
REPLACE ID CODE BOX
OK

END (CERTIFICATION ECU IS DEFECTIVE)