Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

DTC    B2785    Communication Malfunction between ECUs Connected by LIN

for Preparation Click here


DESCRIPTION

This DTC is output when the communication among the certification ECU, instrument panel junction block (main body ECU), ID code box and steering lock actuator (steering lock ECU) stops for 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B2785
LIN communication from certification ECU stops for specified amount of time
  1. Wire harness
  2. ECU aggregation box (certification ECU)
  3. Instrument panel junction block (main body ECU)
  4. Steering lock actuator (steering lock ECU)
  5. ID code box

WIRING DIAGRAM


B128171E01


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Recheck for the DTC.

    OK:
    B2785 output does not reoccur.



OK
NORMAL
NG


2.CHECK WIRE HARNESS (LIN COMMUNICATION LINE)

B122832E02

  1. Disconnect the E6 and E63 ECU connectors.

  1. Disconnect the E51 box connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard Resistance:
    Tester Connection
    Specified Condition
    E63-10 (LIN) - E51-3 (LIN1)
    Below 1 Ω
    E63-10 (LIN) - ID-9 (LIN1)
    E63-10 (LIN) - E6-5 (LIN)
    E63-10 (LIN), E51-3 (LIN1), ID-9 (LIN1) or E6-5 (LIN) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK CERTIFICATION ECU (OPERATION)
  1. Temporarily replace the certification ECU with a new or normally functioning one.

  1. Check for DTC.

    OK:
    B2785 output does not reoccur.



OK
END (CERTIFICATION ECU IS DEFECTIVE)
NG


4.CHECK INSTRUMENT PANEL JUNCTION BLOCK (OPERATION)
  1. Temporarily replacing the instrument panel junction block (main body ECU) with a new or normally functioning one.

  1. Check for DTC.

    OK:
    B2785 output does not reoccur.



OK
END (MAIN BODY ECU IS DEFECTIVE)
NG


5.CHECK STEERING LOCK ACTUATOR ASSEMBLY (OPERATION)
  1. Temporarily replace the steering lock actuator (steering lock ECU) with a new or normally functioning one.

  1. Check for DTC.

    OK:
    B2785 output does not reoccur.



OK
END (STEERING LOCK ECU IS DEFECTIVE)
NG

REPLACE ID CODE BOX