ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) > ID Code Box Power Source Circuit |

| 1.INSPECT FUSE (ECU-B) |
Remove the ECU-B fuse from the engine room No. 2 relay block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (ID CODE BOX - BATTERY AND BODY GROUND) |
![]() |
Disconnect the E51 box connector.
Measure the resistance and voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| E51-8 (GND) - Body ground | Below 1 Ω |
| Tester Connection | Specified Condition |
| E51-1 (+B) - Body ground | 11 to 14 V |
|
| ||||
| OK | ||
| ||