DTC B2796 No Communication in Immobiliser System |
DTC B2798 Communication Malfunction No. 2 |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2796 | No communication |
|
| B2798 | Communication error | Key |

| 1.READ VALUE USING INTELLIGENT TESTER (ENGINE IMMOBILISER SYSTEM) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON with a key that cannot start the engine.
On the intelligent tester, enter the following menus: Body / Immobiliser / Data List / Immobiliser. Read the result.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Immobiliser | Immobiliser system status / Set or Unset | Unset: Key is in ignition key cylinder Set: No key is in ignition key cylinder | - |
|
| ||||
| NG | |
| 2.CHECK WHETHER ENGINE STARTS WITH OTHER KEY |
Check whether the engine starts with the vehicle's other keys.
|
| ||||
| OK | |
| 3.READ VALUE USING INTELLIGENT TESTER (TRANSPONDER KEY COIL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON with a key that cannot start the engine.
On the intelligent tester, enter the following menus: Body / Immobiliser / Data List / Antenna Coil Status. Read the result.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Antenna Coil Status | Transponder key coil condition/ Normal or Fail | Normal: Transponder key coil is normal Fail: Transponder key coil is malfunctioning | - |
|
| ||||
| NG | |
| 4.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER) |
![]() |
Disconnect the E50 ECU connector.
Disconnect the E8 amplifier connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E50-14 (VC5) - E8-1 (VC5) | Below 1 Ω |
| E50-15 (CODE) - E8-4 (CODE) | |
| E50-4 (TXCT) - E8-5 (TXCT) | |
| E50-5 (AGND) - E8-7 (AGND) | |
| E50-14 (VC5) or E8-1 (VC5) - Body ground | 10 kΩ or higher |
| E50-15 (CODE) or E8-4 (CODE) - Body ground | |
| E50-4 (TXCT) or E8-5 (TXCT) - Body ground | |
| E50-5 (AGND) or E8-7 (AGND) - Body ground |
|
| ||||
| OK | |
| 5.CHECK TRANSPONDER KEY AMPLIFIER (OPERATION) |
Temporarily replace the transponder key amplifier with a new or normally functioning one.
Check that the engine starts normally.
|
| ||||
| OK | ||
| ||