Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System)

DTC    B2780    Push Switch / Key Unlock Warning Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output if the transponder key ECU does not detect that the unlock warning switch is ON even when the ignition switch is ON. Under normal conditions, the unlock warning switch is ON when the ignition switch is ON.

DTC Code
DTC Detection Condition
Trouble Area
B2780
Unlock warning switch ON is not detected when ignition switch is ON
  1. Transponder key ECU
  2. Unlock warning switch
  3. Wire harness

WIRING DIAGRAM


B110397E06


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (UNLOCK WARNING SWITCH)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON with a key that cannot start the engine.

  1. On the intelligent tester, enter the following menus: Body / Immobiliser / Data List / Key SW. Read the result.

    Immobiliser 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key SW
    Unlock warning switch signal / ON or OFF
    ON: Key is in ignition key cylinder
    OFF: No key is in ignition key cylinder
    -

    OK:
    ON (key is in ignition key cylinder) appears on the screen.



OK
REPLACE TRANSPONDER KEY ECU
NG


2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY
B115726E01
  1. Remove the unlock warning switch.

  1. Measure the resistance of the switch.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    Not pushed
    10 kΩ or higher



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY
OK


3.CHECK WIRE HARNESS (UNLOCK WARNING SWITCH - BODY GROUND)
B115727E03
  1. Disconnect the E9 switch connector.

  1. Measure the resistance of the wire harness side connector.

    Standard Resistance:
    Tester Connection
    Specified Condition
    E9-2 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU)
B115728E04
  1. Disconnect the E9 switch connector.

  1. Disconnect the E50 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard Resistance:
    Tester Connection
    Specified Condition
    E9-1 - E50-3 (KSW)
    Below 1 Ω
    E9-1 or E50-3 (KSW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU