ENGINE IMMOBILISER SYSTEM (w/o Entry and Start System) > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester ON.
Select the following menu items: Body / Immobiliser / Data List.
Check the results by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG SW | Ignition switch signal / ON or OFF | ON: Ignition switch ON or ACC OFF: Ignition switch off | - |
| Key SW | Unlock warning switch signal / ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder | - |
| +B | +B judgment / Normal or Break | Normal: Battery supply is normal Break: Battery supply is malfunctioning | - |
| Antenna Coil Status | Transponder key coil condition / Normal or Fail | Normal: Transponder key coil is normal Fail: Transponder key coil is malfunctioning | - |
| Permit (Start) | Engine starting control / OK or NG | OK: Engine start is permitted NG: Engine start is not permitted | - |
| Immobiliser | Immobiliser system status / Set or Unset | Unset: Key is in ignition key cylinder Set: No key is in ignition key cylinder | - |
| Master Key | Master key code signal / Unreg or Reg | Unreg: Unmatched master key code is sent Reg: Registered master key code is sent | - |
| Sub Key | Sub-key code signal / Unreg or Reg | Unreg: Unmatched sub-key code is sent Reg: Registered sub-key code is sent | - |
| BCC Malfunction | Transponder chip signal / NG or OK | NG: Incorrect data sent OK: Correct data sent | - |
| Abnormal Function | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| Different Encrypt Code | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| Different Serial Number | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| Frame Error | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| Response | Transponder chip data / NG or OK | NG: Data error OK: Data OK | - |
| Reg Code Space Full | Key registration code memory space full / No or Yes | No: Possible to register more key codes Yes: Cannot register any more key codes | - |
| Transponda M-Code | Number of registered master keys / min.: 0, max.: 15 | Number of registered master keys | - |
| Transponda S-Code | Number of registered sub-keys / min.: 0, max.: 15 | Number of registered sub-keys | - |
| PERFORM ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester ON.
Select the following menu items: Body / Immobiliser / Active Test.
Perform the Active Test by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indic | Turn security indicator light | ON or OFF | - |