THEFT DETERRENT SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTC.
Recheck for DTCs. Based on the DTC output above, try to force output of the same DTC by simulating the symptoms indicated by the DTC.
| Result | Proceed to |
| DTC output does not reoccur | A |
| DTC output reoccurs | B |
|
| ||||
| |||||
| 4.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation check (Click here)
Data List / Active Test (Click here)
Terminals of ECU (Click here)
Inspection (Click here)
| |||||
| 6.ADJUST, REPAIR OR REPLACE |
| |||||
| 7.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|