Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > ECU Power Source Circuit


DESCRIPTION

This circuit provides power to operate the theft warning ECU.

WIRING DIAGRAM


B129962E02


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B)
  1. Remove the ECU-B fuse from the engine room No. 2 relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (THEFT WARNING ECU - BATTERY AND BODY GROUND)
B132525E01
  1. Disconnect the E83 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E83-16 (E) - Body ground
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Specified Condition
    E83-11(+B1) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE THEFT WARNING ECU