THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER (ENGINE HOOD COURTESY SWITCH) |
Check the Data List for proper functioning of the engine hood courtesy switch.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Hood Courtesy SW | Hood courtesy switch / ON or OFF | ON: Engine hood is open OFF: Engine hood is closed | - |
|
| ||||
| NG | |
| 2.INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH) |
![]() |
Disconnect the A60 switch connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Lock (OFF) | 10 kΩ or higher |
| Unlock (ON) | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (THEFT WARNING ECU - ENGINE HOOD COURTESY SWITCH) |
![]() |
Disconnect the E83 ECU connector.
Disconnect the A60 switch connector.
Measure the resistance of the connectors.
| Tester Connection | Specified Condition |
| E83-4 (DSWH) - A60-2 | Below 1 Ω |
| E83-4 (DSWH) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (HOOD COURTESY SWITCH - BODY GROUND) |
![]() |
Disconnect the A60 switch connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| A60-1 - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||