THEFT DETERRENT SYSTEM > Theft Warning Siren Circuit |

| 1.CHECK THEFT WARNING SIREN ASSEMBLY |
![]() |
Measure the voltage of the siren.
| Tester Connection | Condition | Specified Condition |
| L17-1 (+B) - Body ground | Always | 10 to 14 V |
| L17-2 (GND) - Body ground | Always | Below 1 V |
| L17-3 (CONT) - Body ground | When switched from armed state or arming preparation state to disarmed state (1) | Wave pattern (1) shown in chart |
| When switched from arming preparation state to disarmed state (2) | Wave pattern (2) shown in chart | |
| Normal Condition | Approx. 1. 4 V |

|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (THEFT WARNING ECU - THEFT WARNING SIREN) |
![]() |
Disconnect the E83 ECU connector.
Disconnect the L17 siren connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E83-28 (CTLS) - L17-3 (CONT) | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (THEFT WARNING SIREN - BODY GROUND) |
![]() |
Disconnect the L17 siren connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| L17-2 (GND) - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||