THEFT DETERRENT SYSTEM > Security Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR) |
Select the Active Test, use the intelligent tester to generate a command, and then check that the security indicator light operation is normal.
| Item | Test Details | Diagnostic Note |
| Security Indicator | Turns security indicator light ON / OFF | - |
|
| ||||
| NG | |
| 2.CHECK WIRE HARNESS (THEFT WARNING ECU - SECURITY INDICATOR LIGHT) |

Disconnect the E83 ECU connector.
Disconnect the E22*1 or E23*2 light connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E83-29 (IND) - E22-8 (SEC) | Below 1 Ω |
| E22-5 (GND) - Body ground | |
| E83-29 (IND) or E22-8 (SEC) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
| E83-29 (IND) - E23-10 (LP) | Below 1 Ω |
| E23-7 (GND) - Body ground | |
| E83-29 (IND) or E23-10 (LP) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT THEFT WARNING ECU (OUTPUT) |
![]() |
Reconnect the E83 ECU connector.
Disconnect the E22*1 or E23*2 light connector.
Measure the voltage of the ECU.
| Tester Connection | Condition | Specified Condition |
| E83-29 (IND) - Body ground | Security indicator lights up (illuminates for 30 seconds in alarm sounding state and flashes when immobiliser system is operating) | 5 V or more |
|
| ||||
| OK | ||
| ||