Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Security Indicator Light Circuit


DESCRIPTION

When the theft deterrent system is in the disarmed state, the security indicator light will flash continuously if the engine immobiliser system is set, or not illuminate if the engine immobiliser system is not set.
When the theft deterrent system is in the armed state, the engine immobiliser system is automatically set and the security indicator light will flash continuously.
When the theft deterrent system is in the arming preparation state and alarm sounding state, the theft warning ECU causes the security indicator light to illuminate.

WIRING DIAGRAM


B129779E06


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR)
  1. Select the Active Test, use the intelligent tester to generate a command, and then check that the security indicator light operation is normal.

    Theft warning ECU: 
    Item
    Test Details
    Diagnostic Note
    Security Indicator
    Turns security indicator light ON / OFF
    -

    OK:
    Turns security indicator light ON / OFF.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

2.CHECK WIRE HARNESS (THEFT WARNING ECU - SECURITY INDICATOR LIGHT)

B245062E01

  1. Disconnect the E83 ECU connector.

  1. Disconnect the E108*1 or E109*2 light connector.

  1. Measure the resistance of the wire harness side connectors.

    HINT:
    *1: for Manual air conditioning system
    *2: for Automatic air conditioning system


    Standard resistance:
    for Manual air conditioning system:
    Tester Connection
    Specified Condition
    E83-29 (IND) - E108-11 (SEC)
    Below 1 Ω
    E108-8 (E) - Body ground
    E83-29 (IND) or E108-11 (SEC) - Body ground
    10 kΩ or higher
    for Automatic air conditioning system:
    Tester Connection
    Specified Condition
    E83-29 (IND) - E109-11 (LP)
    Below 1 Ω
    E109-8 (GND) - Body ground
    E83-29 (IND) or E109-11 (LP) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.INSPECT THEFT WARNING ECU (OUTPUT)
B122662E02
  1. Reconnect the E83 ECU connector.

  1. Disconnect the E108*1 or E109*2 light connector.

  1. Measure the voltage of the ECU.

    HINT:
    *1: for Manual air conditioning system
    *2: for Automatic air conditioning system

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E83-29 (IND) - Body ground
    Security indicator lights up (illuminates for 30 seconds in alarm sounding state and flashes when immobiliser system is operating)
    11 V to 14 V



NG
REPLACE THEFT WARNING ECU
OK

REPLACE CLOCK SUB-ASSEMBLY (for MANUAL AIR CONDITIONING SYSTEM), HEATER CONTROL PANEL (for AUTOMATIC AIR CONDITIONING SYSTEM)