DTC B2762 Intrusion Sensor Signal Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2762 | After normal / trouble signal is output from intrusion sensor as result of self-diagnosis, following malfunctions are detected:
|
|

| 1.CHECK WIRE HARNESS (OVERHEAD JUNCTION BLOCK - THEFT WARNING ECU AND BODY GROUND) |
![]() |
Disconnect the R8 junction block connector.
Disconnect the E83 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| R8-4 (IOUT) - E83-8 (IOUT) | Below 1 Ω |
| R8-7 (GND) - Body ground | |
| R8-4 (IOUT) or E83-8 (IOUT) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK OVERHEAD JUNCTION BLOCK (OPERATION) |
Temporarily replace the overhead junction block (intrusion sensor) with a new or normally functioning one (Click here).
Check for a DTC.
|
| ||||
| OK | ||
| ||