Home › ENGINE ยท 3ZR-FAE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > PRECAUTION

for Preparation Click here



1.INITIALIZATION

NOTICE:
  1. Perform initialization (throttle position) after replacing the throttle body assembly or cleaning any throttle body components .
  2. Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM .
  3. Perform Reset Memory (CVT initialization) when replacing the CVT assembly, engine assembly or ECM (Click here).
  4. If the ECM is replaced, register the ECM communication ID for the immobiliser system (refer to the Service Bulletin for Registration).


2.EXPRESSION OF IGNITION SWITCH

HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle.
The expressions listed in the table below are used in this section.


Expression
Ignition Switch (position)
Engine Switch (condition)
Ignition Switch off
Off
Off
Ignition Switch ON
ON
On (IG)
Ignition Switch ACC
ACC
On (ACC)
Engine Start
START
Start