UNDERDRIVE CLUTCH > INSTALLATION |
| 1. INSTALL UNDERDRIVE CLUTCH PISTON SET |
![]() |
Coat the underdrive clutch piston with ATF, and install it to the underdrive clutch piston drum.
![]() |
Install the piston return spring to the underdrive clutch drum.
![]() |
Install the clutch balancer to the underdrive clutch drum.
![]() |
Place SST on the clutch balancer and compress the piston return spring with a press.
Using a snap ring expander, install the snap ring to the underdrive clutch drum.
![]() |
Set the end gap of the snap ring in the underdrive clutch drum shown in the illustration.
| 2. INSTALL UNDERDRIVE CLUTCH DRUM O-RING |
![]() |
Coat the new O-ring with ATF, and install it to the underdrive clutch drum.
| 3. INSTALL NO. 1 UNDERDRIVE CLUTCH DISC |
![]() |
Install the 3 plates, 3 discs and flange to the underdrive clutch drum.
![]() |
Using a screwdriver, install the underdrive clutch flange hole snap ring.
Check that the end gap of the snap ring is not aligned with one of the cutouts.
| 4. INSPECT UNDERDRIVE CLUTCH PACK CLEARANCE |
![]() |
Install the underdrive clutch to the transaxle.
Set a dial indicator as shown in the illustration.
![]() |
Measure the underdrive clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| No. | Thickness | No. | Thickness |
| 1 | 3.0 mm (0.118 in.) | 3 | 3.4 mm (0.134 in.) |
| 2 | 3.2 mm (0.126 in.) | - | - |