SLIDING ROOF SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
Sliding roof system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle's Data Link Connector 3 (DLC3). When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.
| CHECK DLC3 |
![]() |
![]() |
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | HIGH-level CAN bus line | Ignition switch off | 54 to 69 Ω |
| CANH (6) - Body ground | HIGH-level CAN bus line | Ignition switch off | 1 MΩ or higher |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch off | 1 MΩ or higher |
| CANL (14) - Body ground | LOW-level CAN bus line | Ignition switch off | 1 MΩ or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Ignition switch off | 1 MΩ or higher |