Home › BODY › SLIDING ROOF › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > Sliding Roof ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof ECU power source circuit.

WIRING DIAGRAM


B130069E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIDING ROOF OPERATION)
  1. Select the Active Test, use the intelligent tester to generate a control command, and then check that the sliding roof operates normally.


Sliding roof ECU 
Item
Test Details
Diagnostic Note
Slide Roof
Operate sliding roof OPEN / DOWN
OPEN / DOWN: Sliding roof OPEN / DOWN operation occurs
OFF: Sliding roof is not operating
-
Slide Roof
Operate sliding roof CLOSE / UP
CLOSE / UP: Sliding roof CLOSE / UP operation occurs
OFF: Sliding roof is not operating
-

OK:
Sliding roof operates normally.



NG
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
OK


2.INSPECT FUSE (S/ROOF, ECU-IG1)
  1. Remove the S/ROOF and ECU-IG1 fuses from the instrument panel junction block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3.CHECK WIRE HARNESS (SLIDING ROOF DRIVE GEAR - BATTERY AND BODY GROUND)


    B130117E03
  1. Disconnect the R9 gear connectors.

  1. Measure the voltage and resistance of the wire harness side connectors.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R9-1 (B) - Body ground
    Always
    11 to 14 V
    R9-5 (IG) - Body ground
    Ignition switch off
    Below 1 V
    R9-5 (IG) - Body ground
    Ignition switch on (IG)
    11 to 14 V

    Standard resistance:
    Tester Connection
    Specified Condition
    R9-2 (E) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)