SLIDING ROOF SYSTEM > Sliding Roof Control Switch Circuit |

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIDING ROOF OPERATION) |
Select the Active Test, use the intelligent tester to generate a control command, and then check that the sliding roof operates normally.
| Item | Test Details | Diagnostic Note |
| Slide Roof | Operate sliding roof OPEN / DOWN OPEN / DOWN: Sliding roof OPEN / DOWN operation occurs OFF: Sliding roof is not operating | - |
| Slide Roof | Operate sliding roof CLOSE / UP CLOSE / UP: Sliding roof CLOSE / UP operation occurs OFF: Sliding roof is not operating | - |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (SLIDING ROOF CONTROL SWITCH) |
Use the Data List to check if the sliding roof switch is functioning properly.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnostic Note |
| Close Switch | Slide switch close signal / ON or OFF | ON: TILT UP switch is pressed OFF: TILT UP switch is not pressed | - |
| Open Switch | Slide switch open signal / ON or OFF | ON: SLIDE OPEN switch is pressed OFF: SLIDE OPEN switch is not pressed | - |
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (MAP LIGHT ASSEMBLY - SLIDING ROOF DRIVE GEAR AND BODY GROUND) |
![]() |
Disconnect the R8 map light connector.
Disconnect the R9 gear connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| R9-7 (DWN) - R8-9 (DOWN) | Below 1 Ω |
| R9-9 (UP) - R8-8 (UP) | Below 1 Ω |
| R8-7 (GND) - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||