Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER AND WASHER SYSTEM (w/ Rain Sensor)

WIPER AND WASHER SYSTEM (w/ Rain Sensor) > Headlight Cleaner Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit detects the conditions of the headlight cleaner switch.

WIRING DIAGRAM


E124998E02


INSPECTION PROCEDURE

1.INSPECT HEADLIGHT CLEANER SWITCH
E125000
  1. Remove the headlight cleaner switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 - 8
    ON
    Below 25 Ω
    OFF
    10 kΩ or higher



NG
REPLACE HEADLIGHT CLEANER SWITCH
OK


2.CHECK WIRE HARNESS (SWITCH - ECU AND RELAY)

E125077E01

  1. Disconnect the E4 switch connector.

  1. Disconnect the A44 relay connector

  1. Disconnect the E18 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E4-8 - A44-2 (H)
    Below 1 Ω
    E4-5 - E18-20 (HRLY)



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK WIRE HARNESS (RELAY - ECU)
E125078E01
  1. Disconnect the A44 relay connector

  1. Disconnect the E18 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A44-1 (HDLO) - E18-20 (HRLY)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE