WIPER AND WASHER SYSTEM (w/ Rain Sensor) > Headlight Cleaner Motor and Relay Circuit |

| 1.REPAIR FUSE (ECU-IG1) |
Remove the ECU-IG1 fuse from the instrument panel junction block.
Measure the resistance of the fuse.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (RELAY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A44 relay connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Switch Condition | Specified Condition |
| A44-3 (IG) - Body ground | Ignition switch on (IG) | 10 to 14 V |
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| A44-4 (E) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY |
![]() |
Remove the headlight cleaner motor.
Apply battery voltage to the headlight cleaner motor and check the operation of the headlight cleaner motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2 | Headlight cleaner motor operation is normal |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (MOTOR - RELAY AND BATTERY) |
![]() |
Disconnect the A43 motor connector.
Disconnect the A44 relay connector.
Measure the voltage of the wire harness side connector.
| Tester Connection | Specified Condition |
| A43-1 - Body ground | 10 to 14 V |
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| A43-2 - A44-6 (PB) | Below 1 Ω |
|
| ||||
| OK | ||
| ||