DTC B1242 Wireless Door Lock Tuner Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1242 | One of following conditions is met:
|
|

| 1.CHECK WIRE HARNESS (CERTIFICATION ECU - DOOR CONTROL RECEIVER) |
![]() |
Disconnect the E63 ECU connector.
Disconnect the L13 receiver connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E63-38 (RDA) - L13-5 (DATA) | Below 1 Ω |
| E63-39 (RSSI) - L13 (RSSI) | |
| E63-29 (RCO) - L13-4 (+5) | |
| E63-38 (RDA) or L13-5 (DATA) - Body ground | 10 kΩ or higher |
| E63-39 (RSSI) or L13 (RSSI) - Body ground | |
| E63-29 (RCO) or L13-4 (+5) - Body ground |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (MAIN BODY ECU - CERTIFICATION ECU) |
![]() |
Disconnect the E19 and E63 ECU connectors.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E19-11 (CANP) - E63-27 (CANH) | Below 1 Ω |
| E19-12 (CANN) - E63-28 (CANL) | |
| E19-11 (CANP) or E63-27 (CANH) - Body ground | 10 kΩ or higher |
| E19-12 (CANN) or E63-28 (CANL) - Body ground |
|
| ||||
| OK | |
| 3.CHECK DOOR CONTROL RECEIVER (+B TERMINAL) |
![]() |
Measure the voltage of the connector.
| Tester Connection | Condition | Specified Condition |
| L13-4 (+5) - Body ground | Ignition switch off, all doors closed and transmitter switch not pressed → pressed | 5 to below 1 V → 5 V |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (DOOR CONTROL RECEIVER - BODY GROUND) |
![]() |
Disconnect the L13 receiver connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| L13-1 (GND) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 5.REPLACE DOOR CONTROL RECEIVER |
Temporarily replace the door control receiver with a new or normally functioning one (Click here, Click here).
Perform the REGISTRATION procedures.
| NEXT | |
| 6.CHECK FOR DTC |
Clear the DTC (Click here).
Check if the same DTC is detected.
|
| ||||
| NG | |
| 7.CHECK ECU AGGREGATION BOX (OPERATION) |
Temporarily replace the ECU aggregation box with a new or normally functioning one.
Check if the same DTC is detected.
|
| ||||
| NG | ||
| ||