WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Entry and Start System) > No Answer-Back |

| 1.READ VALUE USING INTELLIGENT TESTER (DOOR LOCK POSITION SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Item | Measurement Item/Range (Display) | Normal Condition | Diagnostic Note |
| D-Door Lock Pos SW | Driver side door lock position switch signal / ON or OFF | ON: Driver side door is unlocked OFF: Driver side door is locked | - |
| P-Door Lock Pos SW | Passenger side door lock position switch signal / ON or OFF | ON: Passenger side door is unlocked OFF: Passenger side door is locked | - |
|
| ||||
| OK | |
| 2.CHECK WIRELESS DOOR LOCK CONTROL FUNCTION |
Check the wireless door lock control functions by operating the transmitter switches.
| Result | Proceed to |
| Wireless door lock functions are normal but hazard warning light answer-back does not occur | A |
| Wireless door lock functions are abnormal | B |
|
| ||||
| A | |
| 3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (FLSH RELAY, TURN SIGNAL FLASHER RELAY) |
Select the Active Test, use the intelligent tester to generate a control command, and then check that the hazard warning lights flash.
| Item | Test Details | Diagnostic Note |
| Hazard | Turns FLSH relay*1 (turn signal flasher relay*2) ON / OFF | - |
|
| ||||
| NG | |
| 4.CHECK HAZARD WARNING LIGHT |
Check that the hazard warning lights flash continuously when the hazard warning signal switch is pressed.
| Result | Proceed to |
| Hazard warning lights flash continuously (for RHD) | A |
| Hazard warning lights do not flash continuously | B |
| Hazard warning lights flash continuously (for LHD) | C |
|
| ||||
|
| ||||
| A | |
| 5.CHECK WIRE HARNESS (MAIN BODY ECU - TURN SIGNAL FLASHER RELAY) |
![]() |
Disconnect the IT junction block connector.
Disconnect the E81 flasher connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| IT8-7 (HAZ) - E81-8 (HAZ) | Below 1 Ω |
| IT8-7 (HAZ) or E81-8 (HAZ) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||