WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Entry and Start System) > DIAGNOSIS SYSTEM |
| DESCRIPTION |
Wireless door lock control system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle's Data Link Connector 3 (DLC3). In some cases, a malfunction may be occurring in the wireless door lock control system even though the security indicator light is not illuminated. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.
| CHECK DLC3 |
![]() |
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | HIGH-level CAN bus line | Ignition switch off* | 54 to 69 Ω |
| CANH (6) - Battery positive | HIGH-level CAN bus line | Ignition switch off* | 1 kΩ or higher |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch off* | 1 kΩ or higher |
| CANL (14) - Battery positive | LOW-level CAN bus line | Ignition switch off* | 1 MΩ or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Ignition switch off* | 1 MΩ or higher |
![]() |