Make sure the vehicle is in a condition in which the wireless control functions can be operated (see above).
Check the basic functions.
- Check that the transmitter's LED illuminates 3 times when each switch is pressed 3 times.
- HINT:
- If the LED does not illuminate when the switch has been pressed 3 times or more, the battery may be depleted.
Check the chattering prevention function.
- When a switch is pressed, check that the corresponding operation occurs only once. When the switch is held down, check that the corresponding operation occurs only once and does not repeatedly activate. Lastly, when the switch is pressed at 1 second intervals, check that the corresponding operation activates once for each press of the switch.
Check the automatic locking function.
- When all doors are unlocked with the UNLOCK switch and none of the doors are opened or locked within 30 seconds, check that the doors are relocked automatically.
Check the switch operation fail-safe function.
- If the key is in the ignition key cylinder, check that the doors cannot be locked by the LOCK switch. However, this does not apply when the system is in recognition code registration mode.
Check the door ajar warning function.
- If a door is open or not completely closed, check that the doors cannot be locked by the LOCK switch and that the wireless door lock buzzer sounds for 10 seconds.
Check the answer-back function.
- When the LOCK switch is pressed, check that the hazard warning lights flash once and all doors are locked.
- When the UNLOCK switch is pressed, check that the hazard warning lights flash twice and all doors are unlocked.
Check the illuminated entry function.
- When all doors are locked and the UNLOCK switch is pressed, check that the room No. 1 light illuminates (when the light switch is in the DOOR position) and all doors are unlocked.